- Spedizione gratuita in Italia sopra i 50€*
- Supporti su misura per ogni auto e smartphone
With Molex adapter system. 2,7 A charger. With tilt swivel. Fits device without Zebra Original Rugged Boot.
€171,00
Disponibile su ordinazione
| Codice Brodit | 513927 |
|---|---|
| EAN | 7320285139275 |
| Tipologia | Holder attivi per installazioni fisse |
An active holder which is to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior!
You can choose to use the holder as an active holder for charging of your device only, or to connect an adapter to the Molex connector for additional features. Then you can use the holder also for power supply of a GPS receiver or other own solutions (can not be used for data communication or audio connection).
12/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2,7 A charger. Professional installation recommended. The holder is attached onto a tilt swivel so you can easily adjust your device in order to avoid light reflection. Attach onto a ProClip Mounting Platform.
Dimensions: 81 x 112 x 63 mm (W x H x D mm)
Weight: 195 g
Length cabel: 418 cm, (holder + pigtale 25 cm, cabel to box 77cm, box 11cm, box to open end 305 cm.
Please read all of the instructions and look at the pictures before attaching the holder.
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.
2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws.
3. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel and screw it into place. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted.
4. The holder is in place.
